Superhydrophobic Rear Camera Cover Tesla Model 3 & Y

Superhydrophobic Cover for Tesla Model 3 & Y Rear Camera

NOTE! Only fits cars with "Hardware 3" version.

If you are unsure which version you have, you can check it here.

Please note. This product is suitable for:
Model 3 2018-2024
Model Y 2020-2023
 

Are you tired of your rearview camera becoming unusable after just a short drive?
With this cover installed, you can reverse with full visibility, especially good for those with cars without sensors.
We have tested this product ourselves over a period of four weeks and it works beyond all expectations. Must try!

This cover shields your entire rearview camera and protects it with a superhydrophobic film that repels water and dirt.
The film is optically transparent, so it has no impact on autopilot or color reproduction.
Even under extreme conditions, you will still be able to see with your rearview camera.
Condensation may occur on the inside of the cover. This will not affect visibility and will disappear when the temperature stabilizes.

Similar to ceramic coating, this product has a limited lifespan that will vary depending on conditions and mileage, but usually 3-6 months.
The lifespan can be significantly shorter if the car is washed in an automatic car wash. Brushes and nozzles will more quickly remove the coating on the cover.
It is recommended to use self-service washing and avoid washing/wiping the cover itself more than necessary.
Cleaning the film with a standard lens wipe will help extend its lifespan, but eventually you will notice it becomes less slick, and then it should be replaced.

Easy to install. If the license plate frame is in the way, you will probably need to remove it first. Correct installation determines the quality of the result and effect.
Thorough cleaning of the area before installation is important for the cover to be waterproof. The surface must be completely clean, grease-free, and dry before attaching the cover.
If there is a small clear piece of film on the left side of the rearview camera, you should remove it before starting. (It has no function and should have been removed before the car was delivered.)
Install at room temperature, about 20 degrees Celsius is recommended. The adhesive is very sticky and strong and adheres quickly, so make sure to apply it calmly and firmly,
and with the entire surface at once. Hold for 30 seconds for the adhesive to bond well to the surface.


Installation video: